Brother International Laura Ashley Innov-ís NX2000 BOBBIN WORK INSTRUCTIO - Page 13

ENGLISH CAUTION • DO NOT adjust the position of the phillips (+) screw on the bobbin case (gray) as this may result in damage to the bobbin case, rendering it useless. • If the slotted screw (-) is difficult to turn, do not use force. Turning the screw too much or providing force in either (rotational) direction may cause damage to the bobbin case. Should damage occur, the bobbin case may not maintain proper tension. d Press the "Thread Cutter" button again, and then pull the thread out to the left while the thread cutter is operating. Note • If the bobbin thread tension is tight, the thread cannot be passed through the tension spring when the bobbin is installed in the bobbin case. (Refer to "When tension is not applied to the bobbin thread" on page 6.) Troubleshooting Several solutions for minor problems are described below. If the problem persists, contact your nearest authorized dealer. ■ The thread was accidentally cut automatically and the bobbin thread is caught inside the machine a Cut the thread near the fabric above the needle plate, and then remove the fabric. CAUTION • Do not pull on the thread with excessive force, otherwise the machine may be damaged. ■ The pattern is misaligned Refer to"Adjusting the thread tension"and increase the upper thread tension. If the pattern is still misaligned, reduce the tension of the bobbin thread. a Thread b Remove the bobbin, and then hold it out toward the left side of the machine. a Correct tension b The upper thread tension is too loose, or the bobbin thread tension is too tight. ■ The bobbin thread catches on the tension spring of the bobbin case Sew with no tension applied to the bobbin thread. (Refer to "When tension is not applied to the bobbin thread" on page 6.) c Lower the presser foot. 11