Brother International MFC-9320CW Users Manual - English - Page 158
Stop/Exit, Black Start, Color Start, Error Message, Cause, Action, Cooling Down, Wait for a while - fuser
UPC - 012502622406
View all Brother International MFC-9320CW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Error Message Cooling Down Wait for a while Comm.Error Connection Fail Cover is Open Cover is Open DIMM Error Disconnected Document Jam DR Mode in Use Cause Action The temperature of the drum unit or toner cartridge is too hot. The machine will pause its current print job and go into cooling down mode. During the cooling down mode, you will hear the cooling fan running while the LCD shows Cooling Down, and Wait for a while. Make sure that you can hear the fan in the machine spinning and that the exhaust outlet is not blocked by something. If the fan is spinning, remove any obstacles that surround the exhaust outlet, and then leave the machine turned on but do not use it for several minutes. If the fan is not spinning do the following: Disconnect the machine from the power for several minutes, then reconnect it. (The machine can be turned off for approximately 4 days without losing faxes stored in the memory. See Transferring your faxes or Fax Journal report on page 147.) Poor telephone line quality caused a communication error. Send the fax again or connect the machine to another telephone line. If the problem continues, call the telephone company and ask them to check your telephone line. You tried to poll a fax machine Check the other fax machine's polling setup. that is not in Polled Waiting mode. The ADF cover is not closed completely. Close the ADF cover of the machine, then press Stop/Exit. The top cover is not closed completely. The fuser cover is not closed completely or paper was jammed in the back of the machine when you turned on the power. Close the top cover of the machine. Close the fuser cover of the machine. Make sure paper is not jammed inside the back of the machine, and then close the fuser cover and press Black Start or Color Start. The DIMM is not installed correctly. Or the DIMM is broken. Turn off the machine. Re-install the DIMM correctly. Wait a few seconds, and then turn it on again. If this error message appears again, replace the DIMM with a new one. (See Installing extra memory on page 122.) The other person or other Try to send or receive again. person's fax machine stopped the call. The document was not inserted or fed properly, or the document scanned from the ADF was too long. See Document jams on page 148 or Using the automatic document feeder (ADF) on page 23. The machine is set to Distinctive Ring mode. You cannot change the Receive Mode from Manual to another mode. Set Distinctive Ring to Off. (See Turning off distinctive ring on page 56.) 142