Brother International PE-DESIGN Ver.4 3 2 Instructin Manual for PE-DESIGN Ver. - Page 59
Create the pattern, If a pattern does not meet the conditions mentioned above
View all Brother International PE-DESIGN Ver.4 3 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Contents Before Using s Create the pattern 1 The Design Page appears on the screen as shown below. x Explanation of a, b, and c: a a: Embroidering area when the embroidery frame is installed at the top installation position. b: Embroidering area when the embroidery frame is installed at the b middle installation position. c: Embroidering area when the embroidery frame is installed at the bottom installation position. The broken lines indicate each area. c Getting Started Design Center Layout & Editing 2 Create the pattern, making sure that it meets the following conditions. x The size of one pattern must be no bigger than 100 × 100 mm (or 130 × 180 mm). (If the pattern is imported from Design a Center, only these size settings are available.) 1 4 b 23 c x Each pattern must completely fit within one single area (a, b, or c). 1: This pattern is correct since it fits completely within area a. 2: This pattern is correct since it fits completely within either area b or area c. 3: The size of this pattern is acceptable, but its position must be corrected since it does not fit completely within any of the areas. 4: This pattern must be corrected since it is too large. NOTE: If a pattern does not meet the conditions mentioned above, a warning will appear when continuing to the next step. x Specify the sewing order in the same way that it is specified for a normal frame. File Utility Programmable Stich Creator Quik Reference Alphabetic Index With the Optimize hoop change setting, the actual sewing order (including the embroidery frame installation order) is optimized as explained below. (The Optimize hoop change setting can be found on the Sew menu. The setting is turned on when a check mark appears in front of the setting.) • When the Optimize hoop change setting is turned on: 50