Brother International QC-1000 Users Manual - English - Page 13
How to Assemble the Spool Stand
View all Brother International QC-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
NAMES OF MACHINE PARTS AND THEIR FUNCTIONS ■ How to Assemble the Spool Stand a Fully extend the telescopic thread guide shaft, and then rotate the shaft until the two stoppers click into place. c Firmly insert the two spool holes in the spool support. pins into the two b Insert the telescopic hole at the center of thread guide into the round the spool support, and then use a screwdriver to securely tighten the screw from the reverse side. d Open the upper cover of the machine. With your right hand, snap the cover toward the back to release the cover from the latch. Slide the upper cover to the right so that the pin on the left side is disengaged, and then remove the upper cover. b a a a Screw Note Make sure that the stoppers on the telescopic thread guide shaft are firmly in place and that the top of the thread guide is parallel to the spool support. In addition, check that the shaft is straight up from the spool support. a Latch b Pin e Raise the latch on the machine toward you. 12