Brother International Quattro 6000D Operation Manual Kit 1 - English - Page 8
Caution
View all Brother International Quattro 6000D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
ENGLISH Note • The bobbin case (gray) cannot be used for sewing in any way other than bobbin work. After sewing bobbin work, refer back to the steps in "Preparing the Bobbin Thread" on page 6 for removing and cleaning the bobbin case (gray), and then reinstall the standard bobbin case (black). CAUTION • Be sure to use the bobbin case (gray) when creating bobbin work. Using any other bobbin case may result in the thread becoming tangled or damage to the machine. • Make sure that the bobbin case is correctly installed. If the bobbin case is incorrectly installed, the thread may become tangled or the machine may be damaged. h Wind a decorative thread around the bobbin by hand. After winding the bobbin so it is filled as shown below (about 80%), cut the thread. i Using scissors carefully trim the thread tail as close to the bobbin as possible. a Beginning of wound thread CAUTION • If thread extends beyond the top of the bobbin too much, the thread may become tangled or the needle may break. j Install the bobbin wound with thread. Whether or not tension should be applied to the bobbin thread depends on the type of thread being used. ■ When tension is applied to the bobbin thread Insert bobbin into bobbin case so the thread unwinds from the left side. Then correctly pass the thread through the tension spring as shown below. For precautions on winding the bobbin for embroidering, refer to step b of "Selecting the Pattern" on page 13. CAUTION • Be sure to use the machine's included bobbin or one designed specifically for this machine. Using any other bobbin may result in damage or injuries. 11.5 mm (approx. 7/16 inch) Actual size This model Other models Note • Slowly and evenly wind the thread around the bobbin. • For best results, wind the bobbin so the thread is snug and not twisted. a Tension spring 7