Campbell Scientific NL121 NL121 Ethernet Module - Page 11

IP Address, Subnet Mask, Gateway, Eth IP, Apply

Get Campbell Scientific NL121 PDF manuals and user guides View all Campbell Scientific NL121 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

NL121 Ethernet Module c. Under the TCP/IP tab, input the IP Address, Subnet Mask, and IP Gateway. These values should be provided by your network administrator. Alternatively, note the Eth IP address assigned to the datalogger via DHCP. Note, however, that this address is not static and may change. NOTE FIGURE 4-2. DevConfig setup d. Press the Apply button to save the changes and then close DevConfig. A temporary IP address may be obtained from a DHCP server. For more information, see Section 6.8, DHCP (p. 15). NOTE The NL121 must be connected to the datalogger before configuring the datalogger with DevConfig. If it is not connected, the TCP/IP settings will not be displayed. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
NL121 Ethernet Module
c.
Under the TCP/IP tab, input the
IP Address
,
Subnet Mask
, and
IP
Gateway
.
These values should be provided by your network
administrator.
Alternatively, note the
Eth IP
address assigned to the datalogger via
DHCP. Note, however, that this address is not static and may change.
FIGURE 4-2.
DevConfig setup
d.
Press the
Apply
button to save the changes and then close
DevConfig
.
A temporary IP address may be obtained from a DHCP server.
For more information, see Section
6.8
,
DHCP
(p. 15)
.
The NL121 must be connected to the datalogger before
configuring the datalogger with
DevConfig
.
If it is not connected,
the TCP/IP settings will not be displayed.
NOTE
NOTE
3