Canon 7562A002 Instruction Manual - Page 9
Troubleshooting
UPC - 013803010572
View all Canon 7562A002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Troubleshooting If there is a problem with the binoculars, first refer to the table below to see if you can resolve it. If the problem cannot be resolved, take the binoculars to your nearest Canon Service Center. Problem The image is not clear. The Image Stabilizer does not operate. When the binoculars are shaken severely while the Image Stabilizer is operating, there is a strange noise. Probable Cause The lens is dirty. The width of the binoculars does not suit the width between your eyes. The diopter has not been properly set. The binoculars are not properly focused. There are no batteries loaded. When the Image Stabilizer button is pressed, the lamp does not light. The battery power is low. The batteries are exhausted. Corrective Measures Use a blower brush to remove dust, etc., from the lens surface. Then use a soft, dry cloth to wipe the lens gently. Adjust the width of the binoculars (see step 4). Adjust the diopter (see step 5). Focus the binoculars (see step 6). Load batteries having enough power. If the lamp does not light, it means the batteries are exhausted. Replace the batteries with new ones. Even if the lamp lights, the Image Stabilizer may not operate if the batteries are exhausted. Replace the batteries with new ones. Replace the batteries with new ones. ENG-8