Canon EOS C300 PL Instruction Manual - Page 85
Selecting Drop or Non-Drop Frame, Open the [DF/NDF] submenu., Select [DF] or [NDF] and then press SET.
View all Canon EOS C300 PL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Setting the Time Code Setting the Time Code's Initial Value If you set the time code mode to [Preset], you can set the initial value of the time code. 1 Open the time code [Setting] submenu. [¤ TC/UB Setup] [Time Code] 85 [¤ TC/UB Setup] > [Time Code] > [Setting] 2 Select [Set] and then press SET. [Setting] • The time code setting screen appears with an orange selection frame indicating the hours. • To reset the time code to [00:00:00.00], select [Reset] instead. If the running mode is set to [Free Run], the time code will be reset the moment you press SET and keep running continuously from 00:00:00.00. 3 Use the joystick (Ý) or SELECT dial to set the hours and press SET to move to the minutes. 4 Change the rest of the fields (minutes, seconds, frame) in the same way. • Press the CANCEL button to close the screen without setting the time code. 5 Select [Set] and press SET to close the screen. • If the running mode is set to [Free Run], the time code will start running from the selected time code the moment you press SET. Selecting Drop or Non-Drop Frame When [w Other Functions] > [NTSC/PAL] is set to [NTSC], you can select between a drop frame (DF) or non-drop frame (NDF) time code, depending on how you plan to use your recordings. In the following cases, the time code is set to non-drop frame (NDF) and cannot be changed. - [w Other Functions] > [NTSC/PAL] is set to [PAL] - [w Other Functions] > [24.00P] is set to [On] - [w Other Functions] > [NTSC/PAL] is set to [NTSC] and the frame rate is set to 23.98P [¤ TC/UB Setup] [Time Code] [DF/NDF] [DF] 1 Open the [DF/NDF] submenu. [¤ TC/UB Setup] > [Time Code] > [DF/NDF] 2 Select [DF] or [NDF] and then press SET. • The time code display will differ depending on the setting. When you select [DF], the time code will appear as [00:00:00.00]; when you select [NDF], it will appear as [00:00:00:00].