Canon LASER CLASS 830i Getting Started Guide - Page 9
Connect the Power Cord and Turn On the Machine - fax
View all Canon LASER CLASS 830i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Connect the Power Cord and Turn On the Machine 1 Connect the power cord into the rear socket and the wall outlet and press the [I] side of the main power switch to ON. When restarting the machine, wait at least 10 seconds before turning the main power back on. 2 FAX The machine enters standby mode. ˔ is displayed: Make sure that the left cover is closed properly. (See "Install Cartridge" on p. 4.) ˔ is displayed: Make sure that the toner cartridge is installed properly. (See "Install Cartridge" on p. 4.) ˔ is displayed: If this message is displayed after a new toner cartridge has been set in place, reset the toner cartridge after shaking it slowly five, or six times. (See "Install Cartridge" on p. 4.)
8
Connect the Power Cord and Turn On the Machine
1
Connect the power cord into the rear socket and the wall
outlet and press the [I] side of the main power switch to
ON.
When restarting the machine, wait at least ±0 seconds
before turning the main power back on.
2
FAX
The machine enters standby mode.
<LEFT COVER OPEN / CLOSE COVER> is displayed:
Make sure that the left cover is closed properly.
(See “Install Cartridge” on p. 4.)
<TONER IS NOT SET / INSERT TONER> is displayed:
Make sure that the toner cartridge is installed properly.
(See “Install Cartridge” on p. 4.)
<TONER LOW / PREPARE NEW TONER> is displayed:
If this message is displayed after a new toner cartridge
has been set in place, reset the toner cartridge after
shaking it slowly five, or six times. (See “Install Cartridge”
on p. 4.)
●
●
●