Canon PC950 Service Manual - Page 104
Correcting the Transfer Bias Voltage Level ATVC control, Reference
UPC - 030275182316
View all Canon PC950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
CHAPTER 4 IMAGE FORMATION SYSTEM c. Correcting the Transfer Bias Voltage Level (ATVC control) The machine automatically corrects the application voltage level of the transfer bias to correct the changes in the transfer efficiency caused by the deterioration of the transfer roller or the changes in the environment. A current of a specific level (-14.6 µA) is applied to the transfer charging roller during initial rotation executed each time the Copy Start key is pressed. The microprocessor (Q900) on the composite power supply PCB checks the transfer current detection signal (T_FW_S), and varies the transfer bias applied to the transfer charging roller so that it will be an appropriate level. Reference: While the transfer charging roller makes a single rotation, the microprocessor (Q900) checks the transfer current detection signal four times, and determines the level of the transfer bias to apply using the average of the readings. d. Switching the Polarity of the Transfer Bias (cleaning bias) The machine uses a direct charging method, allowing toner to move from the photosensitive drum to the transfer roller as when a jam occurs if left unattended. To remove excess toner, a positive voltage is applied to the transfer roller as follows, thereby returning the toner from the roller to the drum: < Timing > • While initial rotation is executed after the Copy Start key is pressed • Part of the period in which the scanner is moved in reverse • Part of the period in which last rotation is executed The polarity of the transfer bias is switched by the transfer bias ON signal (serial signal) generated by the DC controller PCB. In response to the signal, the microprocessor (Q900) on the composite power supply PCB causes the transfer positive DC bias On signal (T_REV_ON*) to go '0', so that the positive component of the transfer bias (constant current control, + 1.56µA/2.5 kV max.) will be applied to the transfer roller. (See Table 4-103.) Copy Start key ON STBY INTR SCFW SCRV SCFW SCRV LSTR STBY Main motor (M1) Cleaning bias Reference bias (ATVC) Transfer bias 1.2sec (approx.) 0.8sec (approx.) 0.7sec (approx.) 1.6sec(approx.) Figure 4-106 4-10 COPYRIGHT © 1999 CANON INC. CANON PC800s/900s REV.0 AUG. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)