Canon W8200 User Guide - Page 140
Problem 3, Solution, from the Media Take-up Unit.
View all Canon W8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Problem 3: Roll media ran out during the print job and the tape on the trailing edge of the media sheet is preventing the rest of the sheet from feeding. Solution: Follow the procedure for removing a media jam. Remove the used roll and replace it with a new one. (Æ P.2-8, P.7-19) Send the data again in order to restart the print job. Solution: If you are using the Media Take-up Unit, remove previously printed media from the Media Take-up Unit. (Æ P.2-39) Blank paper is ejected from the printer. Problem 1: A blank page is ejected from the previous print job. Solution: The print job starts after the blank page is ejected. Problem 2: The leading edge of the roll media is cut to an even length. Solution: When the roll media was loaded, the ejection of a plain cut sheet was a normal part of the procedure in order to align the roll media correctly. When the preparation is finished, the printer is ready to print. Problem 3: Printhead nozzles are clogged. Solution: Print a nozzle check pattern, check the condition of the printhead nozzles, If you determine that the printhead nozzles are clogged, clean the printhead. (Æ P.7-33) Problem 4: An ink tank has run out of ink. Solution: Check the ink tanks and replace any empty ink tanks. (Æ P.6-2) Problem 5: Printer is damaged. Solution: Call for service. 7-8 Troubleshooting