Canon imagePROGRAF TA-30 MFP L36ei TA-20 / TA-30 Setup Guide - Page 9
lever is aligned with the position of the red, Check that the triangular mark on the angle adjustment
View all Canon imagePROGRAF TA-30 MFP L36ei manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
5 Remove the orange protective caps in the order shown in the diagram. Remove by holding here 6 Align the print head so that the area enclosed by a circle in the diagram is facing you, and carefully push the print head firmly into the printer, ensuring that the part covered by the protective caps does not touch the carriage. Important ● Do not touch the part that was being protected by the protective cap (part shown shaded in the diagram) under any circumstances. Touching it may cause damage to the print head or printing problems. ● The print head is filled with ink. Be careful to avoid getting your clothes and surrounding items dirty when removing the protective caps. It is recommended that you remove the protective caps over the bag that the print head came in. ● Do not reattach the protective caps after removing them. Furthermore, dispose of them according to local regulations. 7 8 Pull the print head locking cover down toward you to lock the print head in place. Push the print head lock lever all the way to the end. 9 Check that the triangular mark on the angle adjustment lever is aligned with the position of the red ■. If it is not aligned, move the angle adjustment lever up or down to align it with the red ■. 10 Close the top cover. Red ■ Triangular mark 8