Cisco AIR-LAP1142N-S-K9 Hardware Installation Guide - Page 44
Mounting on a Cubical Wall Partition
View all Cisco AIR-LAP1142N-S-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Mounting on a Cubical Wall Partition Chapter 3 Mounting Instructions Step 3 Step 4 Rotate the adapter to engage it with the security hasp. The hole in the adapter should be aligned with the hole in the security hasp. Secure the adapter to the security hasp with a padlock. Your installation will look similar to Figure 3-7. Figure 3-7 Security Hasp with Padlock 81176 Mounting on a Cubical Wall Partition Follow these steps to mount the access point on a cubical wall partition. Step 1 Step 2 Step 3 Step 4 Step 5 Select the place on the partition where you want to mount the access point. Determine the width of the partition you are going to mount the access point on. Assemble the cubical partition mounting bracket by sliding the two pieces together. You can use either the short or long part of the bracket to obtain the proper fit to the partition wall. • The bracket is adjustable from 2.125 in. (5.39 cm) to 4.25 in. (10.79 cm). Connect the Ethernet and power cables. Line up the mounting slots on the access point with the mounting rails on the cubical partition mounting bracket and slide it down the rails until it clicks into place. Cisco Aironet 1100 Series Access Point Hardware Installation Guide 3-8 OL-4309-07