Clifford IntelliGuard 750 Owners Guide - Page 11
disarming, disarming without a remote - alarm system
View all Clifford IntelliGuard 750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
When armed, your vehicle is protected as follows: z The LED will flash as a visible theft deterrent. z Light impacts will trigger the Warning Zone signal. When triggered, the siren will sound for a few seconds. z Heavy impacts will trigger the system. The triggered sequence is 30, 60, or 90 seconds of constant siren sounding and flashing parking lights. z If a protected entry (door, hood, or trunk) is opened, the system will immediately trigger the siren and flash the parking lights. If any vehicle glass is broken the system will immediately trigger the siren and flash the lights. disarming To disarm the system, press . You will hear a chirp and the park- ing lights will flash once. If the power locks are connected to the sys- tem, the doors will unlock. If the siren chirps three times when disarm- ing, refer to the Diagnostics section of this guide. This is called Tamper Alert. If the siren is active when the system is disarmed you will hear two chirps but the system is not disarmed. (Refer to the Remote Siren Silencing section of this guide.) However, if the alarm completes the full trigger cycle when disarmed you will hear three chirps. disarming without a remote This feature allows you to disarm the system without the remote should it be lost, damaged, or disabled. In order to disarm without a remote, you must have the vehicle's ignition key, know where the PlainView 2 Valet® button is located, and have the PIN code. Be sure to check with 8