Clifford Matrix 10 Owners Guide - Page 25
code hopping - developer
View all Clifford Matrix 10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Example If Zone 3 was active or triggered, the LED will blink three times with a two-second pause. Then it will blink three times again, and repeat until the ignition is turned on. note: Your system stores the last six triggered zones in memory. If your system has been triggered but the LED has been reset by turning on the ignition, your dealer can still recall the last six zones that were triggered. Contact your dealer for details. code hopping The receiver and transmitters each use mathematical formulas called algorithms to change their codes each time the transmitter is used. This technology has been developed to increase the security of the unit. The control unit knows what the next codes should be. This helps to keep the transmitter "in sync" with the control unit even if you use the remote control out of range of the vehicle. However, if the transmitter has been pressed many times out of range of the vehicle, or if the battery has been removed, it may get out of sync with the control unit and fail to operate the system. To re-sync the remote control simply press of the transmitter several times within range of the vehicle. The alarm will automatically re-sync and respond to the transmitters normally. 26 © 2005 directed electronics, inc.