Clifford Sabre 2 Owners Guide - Page 14
User-selectable features, Programming table for user-selectable features
View all Clifford Sabre 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
User-selectable features Your Sabre II vehicle security system allows you to set many of its features to your own personal preferences. We have made the programming procedures very simple: to make a change, you just press the PlainView switch a few times. The system comes from the factory with all of its features pre-programmed as noted in the table below and on the next page. To change any of the settings, use the following procedure. To restore the feature to its factory setting, just repeat the procedure: 1. Select the feature you wish to program from the table below and on the following page. Note the number of momentary (spring-loaded) presses. 2. Turn your vehicle's ignition switch to its "ON" position. 3. Enter your valet code (see page 8) on the PlainView switch. 4. When the LED turns on, immediately press and release the momentary side of the switch the number of times indicated in the third column of the programming table for the feature you selected (to help you count, you will hear a single chirp confirmation each time you press the momentary side). a. If noted, perform the "Secondary action." 5. Wait 3 seconds. You will hear 1-3 chirps (as noted in the "Program completion confirmation" column) and the LED will turn off. Turn the ignition off. 6. Repeat steps 1-5 for any other features you wish to program. Programming table for user-selectable features Feature Factory setting # of momentary presses Secondary action Program completion confirmation Result AutoArming ON 4 AutoArm & Lock OFF 5 - 1 chirp = OFF Change state from 2 chirps = ON ON to OFF or vice-versa - 1 chirp = OFF Change state from 2 chirps = ON OFF to ON or vice-versa FACT ON 6 - 1 chirp = OFF Change state from 2 chirps = ON ON to OFF or vice-versa Chirp confirmation ON 9 - 1 chirp = OFF Change state from 2 chirps = ON ON to OFF or vice-versa Add a new remote to channel 1 - (arm/disarm) 11 Press remote control button 1 1 chirp Button 1/channel 1 code of the new remote control has been memorized Add a new remote to channel 2 (optional - remote accessory) 12 Press remote control button 2 2 chirps Button 2/channel 2 code of the new remote control has been memorized continued . . . 13