Cobra 29 LTD 29LTDCLASSIC_MANL - Page 12
Channel 1 and 40. This will check SWR for all
View all Cobra 29 LTD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Operation SWR 2 3 CAL RF SIG 1 3 5 7 9 +30dB S/RF SWR CAL NB/ ANL ANL OFF CB B PA VOLUME SQUELCH DYNAMIKE RFGAIN D Note The reading will be slightly higher on Channels 1 and 40 compared to Channel 20. Note When switched to SWR position the meter needle should ideally be as far to the left as possible. Anything over 3 is not acceptable. A slight antenna height adjustment (higher or lower) may be required. Repeat relcalibration steps. OFF MIN MAX MIN MAX 5 While still holding down the mic button, set the S/RF SWR CAL switch to the SWR position, to read the SWR reading. 6 Repeat the same steps two through five on Channel 1 and 40. This will check SWR for all channels. 12
Operation
12
Note
The reading will be slightly high-
er on Channels 1 and 40 com-
pared to Channel 20.
Note
When switched to SWR position
the meter needle should ideally
be as far to the left as possible.
Anything over 3 is not accept-
able.
A slight antenna height
adjustment (higher or lower)
may be required. Repeat relcali-
bration steps.
Repeat the same steps two through five on
Channel 1 and 40. This will check SWR for all
channels.
6
While still holding down the mic button, set
the S/RF SWR CAL switch to the SWR position,
to read the SWR reading.
5
DYNAMIKE
RFGAIN
S/RF
SWR
CAL
NB/
ANL
ANL
OFF
CB
PA
MIN
MAX
MIN
MAX
SQUELCH
OFF
VOLUME
SIG 1
3
5
79
+30dB
2
3
CAL
SWR
RF