Compaq 15-s200 15 Notebook PC 15 TouchSmart Notebook PC 15 Notebook PC 15 Touc - Page 76
Speaker cable, Power connector cable
View all Compaq 15-s200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
NOTE: When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● Memory module (see Memory module on page 76) ● Heat sink assembly (see Heat sink assembly on page 72) To remove the system board: 1. Position the computer upright, and then disconnect the following cables from the system board: (1): Power connector cable (2): Speaker cable (3): Fan cable (4): Display cable 2. Remove the two Phillips PM2.5×5.0 screws (5) that secure the system board to the computer. 68 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
NOTE:
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory module (see
Memory module
on page
76
)
●
Heat sink assembly (see
Heat sink assembly
on page
72
)
To remove the system board:
1.
Position the computer upright, and then disconnect the following cables from the system board:
(1)
: Power connector cable
(2)
: Speaker cable
(3)
: Fan cable
(4)
: Display cable
2.
Remove the two Phillips PM2.5×5.0 screws
(5)
that secure the system board to the computer.
68
Chapter 6
Removal and replacement procedures for Authorized Service Provider parts