Compaq 6000 Maintenance & Service Guide: HP Compaq 6000 and 6080 Pro Busin - Page 57

Preparation for Disassembly See Identifying the Chassis, Routine Care, and Disassembly Preparation on page 37 for initial safety procedures. 1. Remove/disengage any security devices that prohibit opening the computer (External Security Devices on page 89). 2. Close any open software applications. 3. Exit the operating system. 4. Remove any diskette, compact disc, or media card from the computer. 5. Turn off the computer and any peripheral devices that are connected to it. CAUTION: Turn off the computer before disconnecting any cables. Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. In some systems the cooling fan is on even when the computer is in the "Standby," or "Suspend" modes. The power cord should always be disconnected before servicing a unit. 6. Disconnect the power cord from the electrical outlet and then from the computer. 7. Disconnect all peripheral device cables from the computer. 8. Lay the computer down on its side to achieve a safe working position. NOTE: During disassembly, label each cable as you remove it, noting its position and routing. Keep all screws with the units removed. CAUTION: The screws used in the computer are of different thread sizes and lengths; using the wrong screw in an application may damage the unit. Preparation for Disassembly 47