Compaq Evo n800c Regulatory and Safety Notices Compaq Notebook Series - Page 20

Electrostatic Discharge ■ Before touching an electronic component, discharge static electricity by using one of the grounding methods described later in this appendix. If you must leave the area during installation, remember to reground yourself before resuming the installation. ■ Avoid touching pins, leads, and circuitry. Handle electronic components as little as possible. ■ If you remove a component, place it in an electrostatic-safe container. Grounding Methods If installation instructions direct you to unplug the notebook or an optional docking base, unplug it after being properly grounded and before removing the cover. Use one or more of the following grounding methods: ■ Touch the unpainted metal surface or lug nuts on the connectors on the back of the notebook or docking base. Avoid touching connector pins. ■ Touch an exterior unpainted metal surface of equipment that is connected to an electrical outlet by a grounding plug. ■ Use a wrist strap connected by a ground cord to the notebook chassis. Wrist straps are flexible grounding straps with a minimum of one megohm ±10 percent resistance in the ground cords. To provide proper ground, wear the strap snugly against the skin. ✎ If you need more information about static electricity or assistance with product installation, contact your Compaq authorized dealer, reseller, or service provider. 2-2 Regulatory and Safety Notices