Compaq LA2405wg User Guide - Page 17
Removing the Monitor Pedestal Base, Removing the Pedestal Base Screws
View all Compaq LA2405wg manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Removing the Monitor Pedestal Base You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm, or other mounting fixture. CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. Also disconnect all USB cables connected to the monitor. 1. Disconnect and remove the signal, power, and USB cables from the monitor. 2. Lay the monitor face down on a flat surface covered by a clean, dry cloth. 3. Pivot the base 45 degrees clockwise and remove the screw from the back of the monitor, then pivot the base 45 degrees counter-clockwise and remove the other screw from the back of the monitor. Figure 2-9 Removing the Pedestal Base Screws 4. Rotate the base of the monitor up (1) then pull it back (2) to unhinge the tabs on the monitor stand from the slots in the monitor. Figure 2-10 Removing the Pedestal Base Removing the Monitor Pedestal Base 11