Compaq ProLiant 6500 DSS Sizing and Tuning of Oracle8 for Windows NT on Compaq - Page 9
Basic Tuning, Installation Issues
View all Compaq ProLiant 6500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
DSS Sizing and Tuning of Oracle8 for Windows NT on CompaqServers Page 7 Basic Tuning This section contains basic tuning information as it pertains to installation and configuration of the hardware, operating system and Oracle8 server. The Tuning sections of this paper which follow contain information for tuning your DSS system. Installation Issues Flashable ROM Apply the latest Compaq System ROMPaq and Option ROMPaq to the ProLiant Server. Compaq System Configuration During configuration of the ProLiant Server using the latest Compaq System Configuration utility, several settings are recommended. System Primary Operating System = Windows NT version 4.0 or later Specifies the Primary Operating System for initial configuration options. Compaq Memory Base Memory = 640 Kbytes, Linear Contiguously maps all memory so that Compaq Built-In Memory is not available at FA0000, but is instead added into extended memory. The previously reserved memory area at FE0000 is now available for use. Array Configuration Utility Controller Characteristics- Operating System = Windows NT 3.5x or later This sets the drive geometry for the controller to be 32 sectors per track and the striping factor to be 256 for RAID-0 and RAID-1. The drive geometry for the controller is 32 sectors per track and the striping factor is 32 for RAID-5. Log Drives: Array Accelerator Status - Logical Drive # = Disabled Non-Log Drives: Array Accelerator Status - Logical Drive # = Enabled This increases performance of the controller by writing data to RAM on the controller instead of directly to disk. The RAM on the controller is mirrored and backed up by batteries for increased reliability. The memory for the accelerator is either 4MB or 16MB, depending upon the version of the controller board. The accelerator cache can be configured at 100/0 percent, 75/25 percent, 50/50 percent, 25/75 percent or 0/100 percent for the amounts of memory that will be reserved for the read-ahead/write-posting functionality of the accelerator. © 1998 Compaq Computer Corporation, All Rights Reserved Doc No ECG156/0398