Compaq d538 HP Compaq Business Desktop d500 Service Reference Guide, 5th Editi - Page 153
Bottom Access Panel, Preparation for Disassembly
View all Compaq d538 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
Removal and Replacement Procedures- Ultra-Slim Desktop (USDT) Chassis 8.3.2 Bottom Access Panel 1. Prepare the computer for disassembly (Section 8.1, "Preparation for Disassembly"). Ä CAUTION: Before removing the computer access panel, ensure that the computer is turned off and that the power cord is disconnected from the electrical outlet. 2. Lay the computer down so the rubber feet face upward. 3. Loosen the captive thumbscrew 1 that secures the access panel to the computer chassis. 4. Slide the bottom access panel back about 1/2 inch (1.3 cm), then lift it off the unit 2. To install the access panel, reverse the removal procedure. Service Reference Guide 336492-005 8-5
Service Reference Guide
336492-005
8–5
Removal and Replacement Procedures— Ultra-Slim Desktop (USDT) Chassis
8.3.2 Bottom Access Panel
1. Prepare the computer for disassembly (
Section 8.1, “Preparation for Disassembly”
).
Ä
CAUTION:
Before removing the computer access panel, ensure that the computer is turned off and that
the power cord is disconnected from the electrical outlet.
2. Lay the computer down so the rubber feet face upward.
3. Loosen the captive thumbscrew
1
that secures the access panel to the computer chassis.
4. Slide the bottom access panel back about 1/2 inch (1.3 cm), then lift it off the unit
2
.
To install the access panel, reverse the removal procedure.