Craftsman 17713 Owners Manual - Page 10
Maintenance
UPC - 648846005348
View all Craftsman 17713 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Maintenance Filter WARNING: To reduce the risk of I i injury from accidental starting, unplug power cord before changing or cleaning filter. Your filter should be cleaned often to maintain peak vac performance. Easy to Replace Filter 1. Extend the retainer band around the plastic posts on the lid. 2. Remove filter bag off the filter cage. 3. Place the replacement filter on the filter cage until open end touches bottom of rid. 4. Release the retainer band from the plastic post on the lid, holding the filter bag secure to the lid. 5. Make sure the retainer band is positioned on the filter bag covering the black printed line. Handle to Remove Motor Cover Retainer Band ;i:se of Vac Take the dirty filter to a disposal container and gently brush away small dirt particles that may be adhering to the filter material. IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a filter with holes or tears in it. Even a small hole can cause a lot of dust to come out of your vac. Replace it immediately. Installation New filters may be purchased at area Sears retail stores, Sears retail replacement filters ar sold by stock no. 9-16949. NOTE: Before installing the filter on the vac, clean the area of the lid so that the retainer band wilt seal the bag against the lid and stop small particles from bypassing the filter bag. If the filter is clean and not damaged, replace it on the filter cage. tf it cannot be reused, place a new filter over the filter cage. Replace the retainer band around the filter. Make sure the retainer band is positioned on the filter, and the filter completely covers the filter cage. Also, make sure the edges of the filter are completely secured under the retainer band. NOTE: Clean the filter in an open area. Cleaning should be done outdoors and not in the living quarters. Plastic Post_ WARNING: Do not remove the filter cage. It is there to help prevent your fingers from getting into the blower wheel. IMPORTANT: To avoid damage to the blower wheel and motor, always reinstall the filter before using the vac for dry material pick-up. 10