Craftsman 17789 Owners Manual - Page 11

Wet Nozzle To pick up liquids off a smooth surface, use the 2-112" wet nozzle accessory sup- plied with your wet/dry vac. To use this nozzle, simply attach the nozzle to the end of an extension wand. Connect a second extension wand to the first, and connect the 2-112" x 7' hose to the extension wand. Liquids may be picked up by dragging the nozzle across the surface. The squeegee will dry the surface as you vacuum. Replacement rubber for the squeegee nozzle may be obtained through Sears Parts. If the rubber becomes worn, it may be flipped over for use on the opposite side or replaced. '(Replacement service part #822256). To reverse or replace the squeegee: 1. Lay the wet nozzle on a fiat surface with the round inlet opening facing up and the two latches close to you as shown. Latches Nozzle Body 2. Using both hands, lower the nozzle body onto the insert and squeegee with the round opening of the nozzle closest to you. With fingers on the far side and thumbs holding the latches of the removable insert, flip the nozzle over so the latches are on the top and the round inlet opening is facing away from you. Make sure the squeegee stays on the insert pins. 3. Press down with each thumb below the latching tabs until you see and hear the removable insert snap into the nozzle body. Snap the latches over the locking tabs into their original position. II I Insert 2. Using both hands, position each thumb on the removable insert, (below the latches) and two fingers of each hand on each latch, lift and disengage the two latches from the tabs on the nozzle body. 3. Gently pull the latches toward yourself to remove the insert. To reinstall the removable insert correctly, follow these steps: 1. Place the removable insert on a fiat sur- face with the pins positioned upward and the latches close to you as shown. Place the rubber squeegee on the insert, with the pins fitting through the matching holes in the squeegee. (Make sure the new working edge is located farthest from you.) 4. Inspect the pins of the insert to make sure they fit through the holes of the squeegee and fit into the matching slots in the nozzle body. t NOTE: If the pins are out of position, hold the nozzle assembly with both hands and gently twist in opposite directions. The insert pins should snap into proper position. Twist Backward Twist Forward The wet nozzle assembly is ready for wet pickup use. r = • = = r I 11