Craftsman 28790 Operation Manual - Page 10
cutting
View all Craftsman 28790 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Left GroundSpeed Control Lever ,_ Right GroundSpeed & ParkingBrake Lever GrounSdpeedLevers- GregeSdpeedLeversDRIVEPositons START/PAPRoKsitons FuelTank Cap CONTROL FUNCTIONS The information below briefly describes the function of individual controls. Starting, stopping, driving, and mowing require the combined use of several controls applied in specific sequences. To learn what combination and sequence of controls to use for various tasks please read the entire section. Transmission ReleaseLevers RUN Mower"Blade Switch O F F_,,,,,,,_,,_GTA RT ignition Switch Mower cutting t Height Switch Choke (Closed) Choke (Open) Engine Speed (Fast) Ground Speed Levers/ Parking Brake These levers control the ground speed and parking brake of the rider. The left lever controls the left rear drive wheel and the right lever controls the right rear drive wheel and parking brake. Pushing the levers out to the side, away from the operator's lap, locks the parking brake in PARK position (inset, Figure 1). This is the proper position for starting the rider. Pulling the levers in across the operator's lap puts the levers in DRIVE positions. From DRIVE position, moving a lever forward increases the FORWARD speed of the associated wheel. Pulling back on a lever increases the REVERSE speed. The further a lever is pushed, the faster the drive wheel will turn. See DRIVING PRACTICE for steering instructions. _ Engine Speed Control The engine speed control adjusts engine speed. Always set the engine speed to FAST for driving and mowing. Move the engine speed control back to SLOW to decrease engine speed. NEVER turn on the mower blades with the engine speed set to SLOW. Only turn on the mower blades with the engine speed set to FAST. Choke CLOSE the choke for cold starting (pull knob up). OPEN the choke once the engine starts (push knob down). If the engine is warm, it may not require choking. If this is the case, set the choke to OPEN (push the knob down) while cranking the engine. In most cases, you will need to close the choke in order to start the engine. 10