Craftsman 28945 Operation Manual - Page 28
Transaxle Gear - sears
View all Craftsman 28945 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
TRANSAXLE GEAR SHIFT LEVER NEU= TRAL ADJUSTMENT The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows: 1. Make sure transaxle is in neutral (N). NOTE: When the tractor rear wheels move freely, the transaxle is in neutral. 2. Loosen adjustment bolt in front of the right rear wheel. 3. Position the gear shift lever in the neutral (N) position. 4. Tighten adjustment bolt securely. NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position. Gearshift Lever Adjustment Bolt tral Lock Gate TO REMOVE WHEEL FOR REPAIRS 1. Block up axle securely. 2. Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose). 3. Repair tire and reassemble. NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key. 4. Replace washers and snap retaining ring securely in axle groove. 5. Replace axle cover. NOTE: To seal tire punctures and prevent flat tires due to slow leaks, purchase and use tire sealant from Sears. Tire sealant also prevents tire dry rot and corrosion. Washers Retaining Axle Ring\ Cover, \ TO CHECK BRAKE If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced. You may also check brake by: 1. Parktractoronalevel,dryconcreteorpaved surface, depress clutch/brake pedal all the waydown and engage parking brake. 2. Place gear shift lever in neutral position. The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a Sears or other qualified service center. TO START ENGINE WITH A WEAK BAT= TERY ,_,WARNING: Lead-acid batteries gener- ate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries. If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE section of this manual). If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles. TO ATTACH JUMPER CABLES 1. Connect one endofthe RED cable to the POSITIVE (+) terminal of each battery(AB), taking care not to short against tractor chassis. 2. Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery. 3. Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery. TO REMOVE ORDER CABLES, REVERSE 1. BLACK cable first from chassis and then from the fully charged battery. 2. RED cable last from both batteries. Square'@ Key _...... _T-_-c------_ _ (Rear Wheel Only) Weak or Dead Battery Fully Charged Battery 28