Cub Cadet Challenger MX 550 Camo Operation Manual - Page 9
Controls
View all Cub Cadet Challenger MX 550 Camo manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Q 27 13 4 9 10 8 14 15 16 17 5 6 12 11 13 20 19 18 (Q) (D) (C) (B) (E) (F) (A) (O) (N) (J) (K) (M) (L) (H) (I) (P) (G) Controls Refer to Figure 3-2 for location and information of the controls described below. Steering Wheel (A) The steering wheel is used to control the direction of the utility vehicle. Ignition (Not shown) The Ignition is located on the right side of the steering column. High Beam Switch (B) The high beam switch is used to turn the high beams on the headlights "ON" and "OFF.' Figure 3-2 12V Power Outlet (G) The 12V power outlet is used for the convenience of plugging in accessories that require a power source with a maximum load of 5A at 12V. Brake Pedal (H) The brake pedal is used to slow down/stop the utility vehicle. Gas Pedal (I) The gas pedal is used to control the speed of the utility vehicle. 2WD/4WD Switch (J) The 2WD/4WD switch is used to switch between 2WD and 4WD. Headlight/Tail light Switch (C) The headlight/tail light switch turns the headlights, instrument cluster lights and tail lights "ON" and "OFF." Horn (D) The horn activates the horn under the hood when depressed. Hazard Switch (E) The hazard switch turns the hazards "ON" and "OFF." Front Axle Differential Switch (K) The front axle differential switch can "LOCK" or "UNLOCK" the front axle differential. Rear Axle Differential Switch (L) The rear axle differential switch can "LOCK" or "UNLOCK" the rear axle differential. Turn Signal Switch (F) The turn signal switch controls the turn signals and activates the LH or RH turn signals. Winch Control (M) The winch control releases cable on the winch ("OUT") or pulls the cable in ("IN"). Shift Lever (N) The shift lever changes the gears of the utility vehicle between park ("P"), reverse ("R"), neutral ("N"), high ("H") and low ("L"). Parking Brake Lever (O) The parking brake lever activates the utility vehicles parking brake. Glove Box (P) The glove box is a small storage area in the dash on the passenger side of the utility vehicle. Instrument Cluster (Q) The instrument cluster contains: 1 - Tachometer 2 - Parking Brake Indicator 3 - Battery Indicator 4 - Oil Pressure Indicator 5 - Engine Indicator 6 - EPS System Fault * 7 - Left Turn Signal 8 - Right Turn Signal 9 - Hour Meter 10 - Speedometer 11 - Differential Lock Indicator 12 - 2WD/4WD Indicator 13 - Gear Indicator 14 - Seat Belt Indicator 15 - Hazards 16 - High Beam Indicator 17 - Fuel Gauge 18 - Coolant Temperature 19 - Low Beam Indicator 20 - Light Indicator * -- If Equipped Section 3 - Controls & Operation 9