Cub Cadet LGT 1050 Lawn Tractor LGT 1050 Operator's Manual - Page 24
Cutting Deck Removal
View all Cub Cadet LGT 1050 Lawn Tractor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Service Cutting Deck Removal To remove the cutting deck, proceed as follows: 1. Place the PTO/Blade Engage knob in the disengaged (OFF) position and engage the parking brake. 2. Lower the deck by moving the deck lift lever into the bottom notch on the right fender. 3. LocatethePTOclutchunderthefrontofyourtractor.SeeFigure 7-1. 7 NOTE: If there is too much tension on the belt for it to be easily removed from the electric PTO clutch, carefully insert a 3⁄8" drive ratchet wrench (set to tighten) into the square hole found in the left-hand deck idler bracket and pivot it toward the tractor's right side to relieve tension on the belt. See Figure 7-2. Insert Ratchet Here Deck Idler Bracket Belt Keeper Rod Figure 7-1 4. Remove the belt guard and belt as follows Refer to Figure 7-1: a. Remove the hex screws. 5. b. Pullthebeltkeeperrodtotherightanddowntoremove. c. Removethedeckbeltfromaroundthetractor'selectric PTO clutch. Figure 7-2 WARNING! Avoid pinching injuries. Never place your fingers on the idler spring or between the belt and a pulley while removing the belt. Looking at the cutting deck from the left side of the tractor, locate the deck support pin on the rear left side of the deck. 24