Cub Cadet LGTX 1054 LGT 1050 Operator's Manual - Page 20
Cleaning the Tractor - belt
View all Cub Cadet LGTX 1054 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
3. Pop open the protective cap on the end of the oil drain valve to expose the drain port. See Figure 6-1. Figure 6-1 4. Remove the oil fill cap/ dipstick from the oil fill tube. 5. Push the oil drain hose (packed with this manual) onto the oil drain port. Route the opposite end of the hose into an appropriate oil collection container with at least a 2.5 quart capacity, to collect the used oil. 6. The engine is equipped with a twist-and-pull drain port. Turn the oil drain valve 1⁄4-turn, then pull outward to begin draining oil. After the oil has finished draining, push the end of the oil drain valve back in and turn 1⁄4-turn to secure it back in place. Re-cap the end of the oil drain valve to keep debris from entering the drain port. 7. Replace the oil filter as instructed in the Engine Owner's Manual. 8. Refill the engine with new oil. Refer to the Engine Owner's Manual for information regarding the volume and weight of the proper engine oil to use. Air Cleaner Service the pre-cleaner and cartridge/air cleaner element as instructed in the Engine Owner's Manual. Spark Plug The spark plug should be cleaned and the gap reset once a season. Refer to the Engine Owner's Manual for correct plug type and gap specifications. Hydrostatic Transmission The hydrostatic transmission is sealed at the factory and is maintenance-free. The fluid level cannot be checked and the fluid cannot be changed. Battery CALIFORNIA PROPOSITION 65 WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. The battery is sealed and is maintenance-free. Acid levels cannot be checked and fluid can not be added. • Always keep the battery cables and terminals clean and free of corrosive build-up. • After cleaning the battery and terminals, apply a light coat of petroleum jelly or grease to both terminals. CAUTION: If removing the battery for cleaning, disconnect the NEGATIVE (Black) wire from its terminal first, followed by the POSITIVE (Red) wire. When re-installing the battery, always connect the POSITIVE (Red) wire its terminal first, followed by the NEGATIVE (Black) wire. Be certain that the wires are connected to the correct terminals; reversing them could result in serious damage to your engine's alternating system. Cleaning the Tractor Any fuel or oil spilled on the machine should be wiped off promptly. Do NOT allow debris to accumulate around the cooling fins of the engine, the transmission's cooling fan or on any other part of the machine, especially the belts and pulleys. Smart Jet Your tractor's deck is equipped with a water port on its surface as part of its deck wash system. Use the Smart Jet to rinse grass clippings from the deck's underside and prevent the buildup of corrosive chemicals. Complete the following steps AFTER EACH MOWING: 1. Drive the tractor to a level, clear spot on your lawn, near enough for your garden hose to reach. CAUTION: Make certain the tractor's discharge chute is directed AWAY from your house, garage, parked cars, etc. 2. Disengage the PTO (Blade Engage), set the parking brake and stop the engine. 3. Thread the hose coupler (packaged with your tractor's Operator's Manual) onto the end of your garden hose. 20 Section 6 - Maintenance & Adjustments