Cub Cadet PRO Z 160S EFI Owners Manual - Page 13
Controls & Operation
View all Cub Cadet PRO Z 160S EFI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Controls & Operation 3 Brake Pedal Cup Holder Fuel Tank Cap Fuel Level Window Forward Drive Pedal Reverse Drive Pedal Steering Column Adjustment Lever Deck Lift Handle Deck Height Index Control Panel (c)* (b) (d) (e)+ Fuel Valve (f)+ (a) (g)+ Fuel Tank Cap Fuel Level Window LH Transmission Bypass Rod RH Transmission Bypass Rod * - If Equipped + - Optional NOTE: This Operator's Manual covers several models. Tractor features may vary by model. Not all features in this manual are applicable to all tractor models and the tractor depicted may differ from yours. NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that position on the tractor when facing forward while seated in the operator's seat. Steering Column Adjustment Lever The steering column adjustment lever is located on the right side of the steering column. To adjust the angle of the steering column rotate the lever counterclockwise, move the steering column to the desired position and then rotate the lever clockwise to lock it into position. NOTE: Be sure that the steering column adjustment lever is tight to prevent the column from moving when operating the tractor. NOTE: The handle is spring loaded so that it can moved out of the way after tightening. Pull the handle out and rotate it to the desired position. Forward Drive Pedal The forward drive pedal is located on the right side of the machine, along the running board. Press the forward drive pedal forward to cause the tractor to travel forward. Ground speed is also controlled with the forward drive pedal. The further forward the pedal is pivoted, the faster the tractor will travel. The pedal will return to its original/ neutral position when it's not pressed. Reverse Drive Pedal The reverse drive pedal is located on the right side of the tractor along the running board. Ground speed is also controlled with the reverse drive pedal. The further downward the pedal is pivoted, the faster the tractor will travel. The pedal will return to its original/ neutral position when it's not pressed. Brake Pedal The brake pedal is located on the left front side of the running board. The brake pedal can be used for sudden stops or setting the parking brake. NOTE: The brake pedal must be fully depressed to activate the safety interlock switch when starting the rider. T Ignition Switch The ignition switch is located on the RH console to the rear of the throttle control. The ignition switch has three positions as follows: O FF ON STAR STOP - The engine and electrical system are turned off. ON - The tractor electrical system is energized. START - The starter motor will turn over the engine. Release the key immediately when the engine starts NOTE: To prevent accidental starting and/or battery discharge, remove the key from the ignition switch when the tractor is not in use. Deck Height Index The deck height index consists of several holes located on the front of the RH console. Each hole corresponds to a 1⁄4" change in the deck height position ranging from 1" at the lowest notch to 5" at the highest notch. The highest notch is also the transport position and the lowest position is the deck removal/installation position . 5" 4.5 4 3.5 3 2.5 2 1.5 1" NOTE: Do not cut grass in the deck removal/ installation position . Doing so is detrimental to the belt life. Deck Lift Handle The deck lift handle is located on the front of the RH console, and is used to raise and lower the mower deck. Depress the button on the end of the handle and push downward to lower the deck, or pull upward to raise the deck. When the desired height is attained, secure the pin in the desired index hole and release the button on the handle. NOTE: Make certain the deck is secured and the pin is fully inserted into the deck height index. The pin is keyed to help keep it in place and fits into the slotted holes on the deck height index. NOTE: The deck lift handle must always be above the pin, never hang the deck lift handle from the pin when mowing. 13