Cub Cadet RZT L 54-KH RZT L 54 KH Operator's Manual - Page 31
Replacing the Belt
View all Cub Cadet RZT L 54-KH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Replacing the Belt 42" Deck 1. Remove the deck from beneath the tractor, (refer to Deck Removal on page 28). 2. Remove the hex washer screws securing the belt covers to the deck. See Figure 7-8. Belt Cover Hex Washer Screws Spindle Pulley Spindle Pulley Idler Pulley Idler Arm PTO Pulley Belt Guards Idler Pulley Figure 7-8 3. Remove the two idler pulleys by removing the hex screws and flange lock nuts that secure them to the deck and the idler arm. See Figure 7-8. Do not lose any of the hardware when removing the hex screw and flange lock nut. Hex Screw Pulley Cap Flange Lock Nut Pulley Cap Idler Pulleys Washer Belt Guard Flange Lock Nut Washer Belt Guard Idler Arm Hex Screw 6. Place the belt around the idler pulleys removed in step 3 with the "V" side facing in. Once in place, reinstall all the hardware and tighten the flange lock nut to secure the assembly. See Figure 7-8. 7. Route the belt as shown in Figure 7-8 and then reinstall the deck (refer to Deck Installation on page 30). 46" Deck 1. Remove the deck from beneath the tractor, (refer to Deck Removal on page 28). 2. Remove the hex washer screws securing the belt covers to the deck. See Figure 7-9. Hex Washer Screws Belt Cover Spindle Pulley Belt Guard Spindle Pulley Idler Pulley Idler Arm Idler Pulley PTO Pulley Figure 7-10 3. Remove the two idler pulleys by removing the hex screws and flange lock nuts that secure them to the deck and the idler arm. See Figure 7-10. Do not lose any of the hardware when removing the hex screw and flange lock nut. Flange Lock Nut Pulley Cap Idler Pulley Washer Belt Guard Idler Arm Flange Lock Nut Pulley Cap Idler Pulley Spacer Shoulder Spacer Hex Screw Figure 7-9 NOTE: Take note of the position of the belt guards to ensure they are properly re-installed. 4. Remove the belt from the spindle pulleys. 5. Install the new belt around the spindle pulleys as shown and reinstall the belt covers. See Figure 7-8. Flat Washer Hex Screw Figure 7-11 NOTE: Take note of the position of the belt guard to ensure they are properly re-installed. Section 7 - Service 31