Cub Cadet SC 500 z SC 500 z Operator's Manual - Page 19
Troubleshooting
View all Cub Cadet SC 500 z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Troubleshooting 8 Problem Engine Fails to start Engine runs erratic Engine overheats Occasional skips (hesitates) at high speed Idles poorly Excessive Vibration Mower will not mulch grass Cause Remedy 1. Blade control disengaged. 2. Spark plug boot disconnected. 3. Fuel tank empty or stale fuel. 4. Engine not primed (if equipped with primer). 5. Faulty spark plug. 6. Blocked fuel line. 7. Engine flooded. 8. Fuel valve (if equipped) closed. 9. Engine not choked (if equipped with choke). 10. Burnt fuse. (Electric Start only) 1. Spark plug boot loose. 2. Blocked fuel line or stale fuel. 3. Vent in gas cap plugged. 4. Water or dirt in fuel system. 5. Dirty air cleaner. 6. Unit running with CHOKE (if equipped) applied. 1. Engine oil level low. 2. Air flow restricted. 1. Spark plug gap too close. 1. Engage blade control. 2. Connect wire to spark boot. 3. Fill tank with clean, fresh gasoline. 4. Prime engine as instructed in the Operation section. 5. Clean, adjust gap, or replace. 6. Clean fuel line. 7. Wait a few minutes to restart, but do not prime. 8. Open fuel valve. See engine manual. 9. Choke engine. See engine manual. 10. Replace fuse (see Service Section). 1. Connect and tighten spark plug boot. 2. Clean fuel line; fill tank with clean, fresh gasoline. 3. Clear vent. 4. Drain fuel tank. Refill with fresh fuel. 5. Refer to engine manual. 6. Push CHOKE knob in. 1. Fill crankcase with proper oil. 2. Clean area around and on top of engine. 1. Adjust gap to .030". 1. Spark plug fouled, faulty, or gap too wide. 2. Dirty air cleaner. 1. Cutting blade loose or unbalanced. 2. Bent cutting blade. 1. Wet grass. 2. Excessively high grass. 3. Dull blade. 1. Reset gap to .030" or replace spark plug. 2. Refer to engine manual. 1. Tighten blade and adapter. Balance blade. 2. See an authorized service dealer. 1. Do not mow when grass is wet; wait until later to cut. 2. Mow once at a high cutting height, then mow again at desired height or make a narrower cutting path. 3. Sharpen or replace blade. Continued on next page 19