Cub Cadet Z-Force S 48 Z-Force S 48 Operator's Manual - Page 14
Transmission Oil Expansion Reservoir Not Shown
View all Cub Cadet Z-Force S 48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Choke Control The choke knob controls the position of the engine choke and is located on the RH console. CHOKE Pull the knob out to choke the engine; push the knob in to open the choke. Parking Brake Engagement Lever The parking brake engagement lever is located on the left of the seat box frame, and is used to engage the parking brake. Pull the lever reward to stop the tractor or slow it down. Pull the lever fully rearward and to the right; then into the short "J" slot to engage the brake. Pull the lever up out of the "J" slot and to the left; then completely forward to disengage the parking brake. Drive Pedal The drive pedal is located on the right side of the tractor, along the running board. Press the drive pedal forward to cause the tractor to travel forward. Ground speed is also controlled with the drive pedal. The further forward the pedal is pivoted, the faster the tractor will travel. The pedal will return to its original position when it's not pressed. Reverse Pedal The reverse pedal is located on the right side of the tractor along the running board. Ground speed is also controlled with the reverse pedal. The further downward the pedal is pivoted, the faster the tractor will travel. The pedal will return to its original position when it's not pressed. Cup Holder The cup holder is located on the LH console to the left of the operator's seat. Storage Tray The storage tray is located at the rear of the LH console. Seat Adjustment Lever The seat adjustment lever is located below the front/left of the seat. The lever allows for adjustment of the fore to aft position of the operator's seat. Refer to the Maintenance & Adjustments section for instructions on adjusting the seat position. Steering Tilt Pedal The steering tilt pedal is located at the bas of the steering column. To increase or decrease the angle of the steering column press down on the steering tilt pedal, move the steering wheel column to the desired position and release the pedal. REVISIONS REV DESCRIPTION T00 Release For Tooling Transmission Oil Expansion Reservoir (Not Shown) Equipped on Z-Force S60 & Z-Force S54 The transmission oil expansion reservoir is connected by hoses to the RH and LH transmission assemblies, and is located behind the seat box. The function of the reservoir is to hold the natural expansion of transmission oil that occurs as the transmission warms up during operation. DO NOT FILL THE RESERVOIR. Under normal operating conditions, no oil should be added to the reservoir. The COLD oil level should be no higher than approximately 1⁄4" (the "Full Cold" mark) above the bottom of the reservoir. See Figure 4-9. Full Cold Line Figure 4-9 NOTE: Prior to the initial operation of the tractor, the oil level in the reservoir may be slightly higher than the maximum due to air in the oil lines. Operation of the tractor will eventually purge the air from the lines and the oil level will settle to the maximum. 14 Section 4- Controls & Features