Cuisinart DCC 590 Use and Care Manual - Page 5

• On/Off 00 1-4 Cup 7032 0 0 Hour Min Program • Program Set 0 0n/Off ° Grind Off Control Panel (Detailed programming instructions are on pages 8 and 9) 1. On/Off Switch with LED Indicator a. Audible Tone (not shown): The Grind & Brew Thermal- Automatic coffeemaker is equipped with an audible tone which will sound 5 times when the coffee has completed brewing (coffee may continue to stream from the filter for several seconds afterwards.) Unit will automatically shut off. 2. Low Cups Setting with LED Indicator Set to "1-4 cup" to improve extraction and flavor when making fewer than 5 cups of coffee. 3. Hours Set/Minutes Set Press and hold either hour or minute button for approximately 2 seconds to enter Time Set Mode. 4. Clock Display Displays time of day and program setting when program dial is rotated 5. Grind Off with LED Indicator Use to turn off the grinder when using pre-ground coffee. 6. Program Setting with LED Indicator Rotate dial to display program setting or to set for programmed brewing. PROGRAMMING YOUR COFFEEMAKER 1. Setting the Clock When the coffeemaker is plugged in, 12:00 will appear until you set the time. Entering "Time Set" Mode To set the time, hold down either the "Hours" or "Minutes" button until the clock begins flashing (about 2 seconds). You are now in the "Time Set" mode and can operate either button to achieve the desired setting. The buttons can be held down to scroll through the digits, or pressed and released lightly to advance one digit at a time. When scrolling, the numbers will advance slowly at first and then speed up to the rate of about three per second. When the number displayed approaches the desired setting, release the button and press repeatedly to advance one digit at a time. Be careful to make sure that the PM indicator is on if a PM time is desired. Exiting "Time Set" Mode The "Time Set" mode can be exited in one of two ways: 1. Press any button besides the "Hours" or "Minutes" button. This will exit the "Time Set" and activate the selected function. 2. Do nothing. If neither the "Hours" nor "Minutes" button is pressed for a period of five seconds, the "Time Set" mode will be exited. flash. This signals that you have entered the Set Program Time mode. The desired time can be set by pressing the Hours and Minutes buttons to scroll forward through the digits. Pressing and holding either button will allow you to scroll continuously, slowly at first, and then to accelerate to the rate of about three digits per second. As the desired time setting approaches, release the button and then press repeatedly to advance one digit at a time. Note: To exit the Set Program Time mode, do nothing. If neither the Hours nor Minutes button is pressed for a period of five seconds, the Set Program Time mode will be exited and the programmed time will hold. Set Program On Rotate and release Program Dial clockwise to Program On/Off. The LED display will turn green and the coffeemaker will start to brew at the programmed time. The Program mode cannot be entered if the coffeemaker is in its brew or keep warm cycle. Note: To turn off the programmed setting, rotate and release Program Dial clockwise to Program On/Off. The LED display will turn off and the Program mode is off. Turning off Grind Function To turn off the grinding function, press the "Grind Off" button. An amber LED will be illuminated. Rotate the On/Off dial clockwise to the On/Off position and release. 2. Setting the Program Time When you rotate the Program Dial counterclockwise to Program Set, it displays the current program time (default time 12:00 p.m.). Entering "Set Program Time" Mode Rotate and release the Program Dial counterclockwise to Program Set. The green light and LCD display will begin to 8