D-Link DSS 24 User Guide

D-Link DSS 24 - Plus Switch Manual

D-Link DSS 24 manual content summary:

  • D-Link DSS 24 | User Guide - Page 1
    DSS-24 Auto Negotiation Switch User's Guide Rev. 02 (Oct, 2004) 651DS24..K15 i
  • D-Link DSS 24 | User Guide - Page 2
    the back of this manual, must be sent to a D-Link office. To obtain an RMA number for warranty service as to a hardware product, or to obtain warranty service as to a software product, contact the D-Link office nearest to you. D-Link Offices to Contact for Warranty Service: To mail your Registration
  • D-Link DSS 24 | User Guide - Page 3
    revised without prior notice. FlexSWITCHTM is a trademark of D-Link Systems, Inc. Ethernet is a trademark of Xerox Corporation. Microsoft Windows is a energy and, if not installed and used in accordance with this user's guide, may cause harmful interference to radio communications. Operation of this
  • D-Link DSS 24 | User Guide - Page 4
    . den Orginalteilen entsprechende Teile verwendet werden. Der Einsatz von ungeeigneten Ersatzteilen kann eine weitere Beschädigung hervorrufen. Wenden Sie sich mit allen Fragen die Service und Repartur betreffen an Ihren Servicepartner. Somit stellen Sie die Betriebssicherheit des Gerätes sicher. iv
  • D-Link DSS 24 | User Guide - Page 5
    11 3 ...12 NETWORK CONNECTIONS...12 CABLE SPECIFICATIONS...12 Copper Cable ...12 PORTS...15 RS-232 Port...15 MDI-II Uplink Port...15 MDI-X Ports...15 4 ...16 LEDS ...16 5 ...18 MANAGING THE DSS-24 ...18 PANEL CONVENTIONS...19 PANELS...20 CONFIGURATION EXAMPLES ...21 6 ...23 TROUBLESHOOTING ...23 v
  • D-Link DSS 24 | User Guide - Page 6
    APPENDIX A ...25 DSS-24 TECHNICAL SPECIFICATIONS 25 Switch Specifications ...25 Port Specifications...25 INDEX ...29 vi
  • D-Link DSS 24 | User Guide - Page 7
    the features of the DSS-24 10/100 Auto Negotiation Switch. Henceforth this manual will refer to the DSS-24 10/100 Auto Negotiation Switch as the DSS-24. Information about the DSS-24 and other D-Link products is available on our web site at www.dlink.com. Audience This user guide is intended for the
  • D-Link DSS 24 | User Guide - Page 8
    dealt with in more detail later in the manual. The topics covered are: • Summary of Features • Explanation of Front and Rear Panels • Management Features The DSS-24 has the following features: • 24 NWAY 10/100-TX Fast Ethernet Ports. • All ports support both Full Duplex and Half Duplex operation and
  • D-Link DSS 24 | User Guide - Page 9
    and hubs that do not have uplink ports. Power Link/ Act/ Collision LEDS MDI-II Uplink Port MDI-X Ports DSS-24 Power 10/100 Fast Ethernet Switch Switch II Link/ 100 Mbps/ Collision 10 Mbps 1 234 56 7 9 10 11 12 Link/ 100 Mbps/ D-Link Collision 10 Mbps 13 14 15 17 18 19 21 22 23 17x
  • D-Link DSS 24 | User Guide - Page 10
    DSS-24 10/100 Auto Negotiation Switch User's Guide Side Panel There are two fans. The fans come on when the DSS-24 is powered on. The three holes on each side of the DSS-24 are used to attach the mounting brackets. There are heat vents located on the side opposite the fans. The fans and the heat
  • D-Link DSS 24 | User Guide - Page 11
    DSS-24 10/100 Auto Negotiation Switch User's Guide Management The DSS-24 is an unmanaged switch. The only management options are setting port speed and duplex mode, and enabling and disabling flow control. The only way of changing the default settings is through a physical connection with an RS232
  • D-Link DSS 24 | User Guide - Page 12
    DSS-24 10/100 Auto Negotiation Switch User's Guide 2 Installing the DSS-24 This chapter covers the following: • Unpacking the DSS-24 • Installation options and instructions • Powering on the DSS-24 Unpacking the DSS-24 Open the box and carefully unpack the DSS-24. You should have all the items on
  • D-Link DSS 24 | User Guide - Page 13
    24 10/100 Auto Negotiation Switch User's Guide Installation Options There are two options for installing the DSS-24: desktop/shelf installation or rack installation. The procedures for each are explained in the following sections. The following tools and materials may be necessary to install the DSS
  • D-Link DSS 24 | User Guide - Page 14
    DSS-24 10/100 Auto Negotiation Switch User's Guide Figure 4: Install Feet on Bottom Figure 5: Attach Feet Installing the DSS-16 and DSS-24 8
  • D-Link DSS 24 | User Guide - Page 15
    DSS-24 10/100 Auto Negotiation Switch User's Guide Rack Installation The DSS-24 can be mounted in an EIA standard size 19 inch rack. The dimensions are: 441 mm (17.44 inches) x 235 mm (10.03 inches) x 55 mm (2.16 inches), 1.25 U. DSS-24 can be placed in a wiring closet along with other equipment.
  • D-Link DSS 24 | User Guide - Page 16
    DSS-24 10/100 Auto Negotiation Switch User's Guide Figure 7: Insert into Rack Installing the DSS-16 and DSS-24 10
  • D-Link DSS 24 | User Guide - Page 17
    is a problem. Contact D-Link Systems, Inc. for technical support. After a power failure, it may be necessary to reconfigure any ports that were manually set. All other ports should automatically negotiate the proper speed and duplex mode. The DSS-24 can be used with power sources in the range 100 to
  • D-Link DSS 24 | User Guide - Page 18
    DSS-24 10/100 Auto Negotiation Switch User's Guide 3 Network Connections This chapter covers the following: • Cable Specifications • Ports • Connecting the DSS-24 to other devices This section deals with making cables and connecting the DSS-24 to other devices. It is extremely important that cables
  • D-Link DSS 24 | User Guide - Page 19
    DSS-24 10/100 Auto Negotiation Switch User's Guide Table 1: Cable Specifications Ethernet Type 10BASE-T 100-TX Cable Requirements Category 3, 4, 5 UTP or STP Category 5 UTP or STP Maximum Length 100 m (328 feet) 100 m (328 feet) Network Connections 13
  • D-Link DSS 24 | User Guide - Page 20
    DSS-24 10/100 Auto Negotiation Switch User's Guide Figure 8: Cable Diagram Network Connections 14
  • D-Link DSS 24 | User Guide - Page 21
    DSS-24 10/100 Auto Negotiation Switch User's Guide Ports There are three types of ports on the DSS-24: RS-232, MDI-II Uplink, and MDIX. RS-232 Port The RS-232 port, located at the rear, is used to configure the DSS-24. Follow these steps to connect the DSS-24 and a workstation or laptop: 1. Plug one
  • D-Link DSS 24 | User Guide - Page 22
    -24 10/100 Auto Negotiation Switch User's Guide 4 LEDs The LED panel of the DSS-24, displayed in Figure 9, is designed to give you critical information at a glance. The LEDs indicate the following: • Power • Link • Activity • Collision • Speed All LEDs are described in detail. See Table 2: Per Port
  • D-Link DSS 24 | User Guide - Page 23
    DSS-24 10/100 Auto Negotiation Switch User's Guide Link Power Power Act Collision Link/ 100Mbps/ Collision 10Mbps 1 234 56 7 9 10 11 12 Link/ 100Mbps/ Collision 10Mbps 13 14 15 17 18 19 21 22 23 100Mbps/ 10Mbps Figure 9: DSS-24 LED Panel Table 2: Per Port LEDs LED Dark (Off) Link/
  • D-Link DSS 24 | User Guide - Page 24
    DSS-24 10/100 Auto Negotiation Switch User's Guide 5 Managing the DSS-24 The DSS-24 is an unmanaged switch. You can change two values: the physical state of the ports and the flow control. You cannot make any other changes and configurations. The only way to change the configuration is to
  • D-Link DSS 24 | User Guide - Page 25
    DSS-24 10/100 Auto Negotiation Switch User's Guide Panel Conventions The following panel conventions are used on the DSS-24: • The Arrow and Tab keys can be used to select items. . If settings have been modified, changes take effect. • EXIT ends the management session. Managing the DSS-24 19
  • D-Link DSS 24 | User Guide - Page 26
    DSS-24 10/100 Auto Negotiation Switch User's Guide Panels Each panel of the DSS-24 covers eight ports. You will have either two or three panels. There are no other menus or panels available. Each panel has four columns: Port, Physical, Flow Control and Link Status. Port Port indicates the port
  • D-Link DSS 24 | User Guide - Page 27
    DSS-24 10/100 Auto Negotiation Switch User's Guide Configuration Examples The following figures give examples of possible configurations. The figures are examples. They are intended to illustrate the functions of the DSS-24. The settings displayed on your switch may be different. Remember that the
  • D-Link DSS 24 | User Guide - Page 28
    DSS-24 10/100 Auto Negotiation Switch User's Guide Ports 1 and 2 have been connected to the network. The DSS-24 has auto negotiated the proper speed and duplex mode, displayed in Figure 11. No further configuration is necessary. Figure 11: Auto Negotiation The speed and duplex mode on port 1 has
  • D-Link DSS 24 | User Guide - Page 29
    10/100 Auto Negotiation Switch User's Guide 6 Troubleshooting This troubleshooting section is intended to help you solve the most common problems on the DSS-24. Problem Solution Cables Port States Power LED is Off All LEDs are Off Faulty cable is the most common source of problems on Ethernet
  • D-Link DSS 24 | User Guide - Page 30
    DSS-24 10/100 Auto Negotiation Switch User's Guide default value is that all ports auto negotiate the proper speed and duplex mode. If the port has been manually configured for a particular speed and duplex mode, verify that the speed and duplex mode of the port match the speed and duplex mode of
  • D-Link DSS 24 | User Guide - Page 31
    DSS-24 10/100 Auto Negotiation Switch User's Guide Appendix A DSS-24 Technical Specifications Switch Specifications • Complies with IEEE 802.3 CSMA/CD 10BASE-T Ethernet • Complies with IEEE 802.3u 100BASE-TX Fast Ethernet • NWAY Auto-negotiation for each 10/100-TX network port providing auto-
  • D-Link DSS 24 | User Guide - Page 32
    DSS-24 10/100 Auto Negotiation Switch User's Guide General Standards: Protocol: Data Transfer Rate: Topology: IEEE 802.3 10BASE-T Ethernet IEEE 802.3u 100-TX Fast Ethernet ANSI/IEEE Std 802.3 NWAY™ Auto Negotiation IEEE 802.3 Frame types: Transparent IEEE 802.3 MAC layer frame size: 64-1518 CSMA/
  • D-Link DSS 24 | User Guide - Page 33
    DSS-24 10/100 Auto Negotiation Switch User's Guide AC inputs: Maximum Power Consumption: DC fans: Operating Temperature: Storage Temperature: Humidity: Dimensions: Weight: EMI: Physical and Environmental 100 - 240 VAC, 50/60 Hz (internal universal power supply) 33 watts 2 built in 40 x 40 mm fans
  • D-Link DSS 24 | User Guide - Page 34
    DSS-24 10/100 Auto Negotiation Switch User's Guide Transmission Method: RAM Buffer: Filtering Address Table: Packet Filtering/ Forwarding Rate: Performance Store-and-Forward 1.5 M bytes per device 8 K entries per device 148810 pps per port (for 100 Mbps) Appendix A 28
  • D-Link DSS 24 | User Guide - Page 35
    features 2 Flow Control 20 front panel 3 I installation 7 L link 16 Link Status 20 M management 5 MDI-X port 15 Index P Panel Conventions 19 Panels 20 Physical 20 Port 20 ports 15 power 16 R rear panel 4 RS-232 port 15 RS-232 port settings 18 S side panels 4 U unpacking 6 Uplink
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35

i
DSS-24 Auto Negotiation Switch User’s
Guide
Rev. 02 (Oct, 2004)
651DS24..K15