D-Link DXS-3600-EM-4QXS CLI Guide - Page 44

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to display the expert ACL, applied to the interface. DXS-3600-32S#show expert access-group Interface tenGigabitEthernet 1/0/2: expert access-group exp1 in DXS-3600-32S# 3-23 vlan access-map This command is used to create a submap. This command will enter into the access-map configuration mode. The no form of this command deletes the submap. vlan access-map map_name [map_sn] no vlan access-map map_name [map_sn] Parameters map_name map_sn Specifies the name of the hostmap to be configured. The name can be up to 32 characters long. Specifies the sequence number of the submap. Default Command Mode Command Default Level Usage Guideline None. Global Configuration Mode. Level: 12 A sequence number will be assigned automatically if the user did not assign it manually. Automatic assignment of the sequence number starts from 10 and increases by 10 for every new entry. Example This example shows how to create a VLAN access map. DXS-3600-32S#configure terminal DXS-3600-32S(config)#vlan access-map vlan-map 20 DXS-3600-32S(config-access-map)# 3-24 match ip / mac address This command is used to associate an IP ACL or MAC ACL with a specific submap. The no form of this command removes the configuration. match ip address {acl_name | acl_id}+8 no match ip address {acl_name | acl_id}+8 match mac address {acl_name | acl_id}+8 no match mac address {acl_name | acl_id}+8 Parameters acl_name acl_id +8 Speicifies the name of the ACL to be configured. The name can be up to 32 characters long. Specifies the sequence number of the ACL. Input parameters can be continuously, but not more than 8 times. Default Command Mode None. Access-map Configuration Mode. 36