Home » DELPHI Manuals » Electronics Accessories » DELPHI SA10046 » Manual Viewer

DELPHI SA10046 Installation Guide

DELPHI SA10046 - XM SKYFi Marine Manual

UPC - 689604154939

View all DELPHI SA10046 manuals

Add to My Manuals
Save this manual to your list of manuals

DELPHI SA10046 manual content summary:

DELPHI SA10046 | Installation Guide - Page 1
the SKYFi Operating Guide contain important safety and operating information. Please read and follow the instructions in these manuals. Failure to do so could result in personal injury, death, and/or damage to your SKYFi Receiver and/or to your boat or other property. Delphi XM® SKYFi™ Marine Kit
DELPHI SA10046 | Installation Guide - Page 2
proof case with rubber gasket XM Universal Audio Adaptor • Two 5/8" rubber sealing bands Before You Begin Please read all instructions thoroughly before installing your Delphi XM SKYFi Marine Kit. Figure 1. Delphi XM SKYFi Marine Kit components Note: See SKYFi Operating Guide for important user
DELPHI SA10046 | Installation Guide - Page 3
Hooking Up The Cradle For SkyFi Receiver Figure 2. Connect accessories to the cradle as shown. 3 To help protect your Universal Audio Adaptor, cover the switches with rubber sealing bands as shown.
DELPHI SA10046 | Installation Guide - Page 4
Antenna Installation Pre-installation signal check • If you do not receive a signal or the display The XM Marine Antenna is easy to install on most boats using the following steps: • Before starting, make sure SKYFi is not docked in its cradle. • Firmly push the end of the antenna cable reads
DELPHI SA10046 | Installation Guide - Page 5
Delphi XM SKYFi Marine Kit are specially chosen and attached at the factory to ensure they will work with XM's unique fre- quency band. Failure to do so could damage the unit. Coil and secure any excess cable. Caution: Refrain from using food or drinks near the SKYFi Receiver to the satellite.
DELPHI SA10046 | Installation Guide - Page 6
from multiple suppliers, Blocked Signals including Boaters World and West Marine.) • The antenna should be placed in a location Incorrect , plan how to route the antenna cable from this location to the receiver, avoiding blocked passages and any obstructions that could Figure 5. Correct and
DELPHI SA10046 | Installation Guide - Page 7
(if used) and out cabin window opening. Drill new holes 7 as necessary. through the access hole on the side of 9. When you reach the receiver location, fol- the mounting bracket. If an antenna low these steps to attach the antenna cable: extension is not used, firmly tighten • Attach the
DELPHI SA10046 | Installation Guide - Page 8
note which one does You can listen to XM Satellite Radio directly through your FM radio using the XM Universal Audio Adaptor. To install the adaptor, follow the steps below. (See figure 2 on page 3.) Adaptor cable into the plug on the SKYFi marine cradle labeled "Line Out." Configuring the Adaptor
DELPHI SA10046 | Installation Guide - Page 9
long as there is an the XM Universal Audio Adaptor frequency XM Satellite Radio signal available from the to hear the XM programming. receiver. There may be situations under Note (up to a minute) after the receiver is switched off. with your Delphi XM SKYFi Marine Kit. See figure 2 on page 3.
DELPHI SA10046 | Installation Guide - Page 10
Splash-proof Case Your Delphi XM SKYFi Marine Kit includes a splash-proof case designed to help protect your SKYFi Receiver from water damage. The cradle can be installed in the case as follows: 1. First, attach all of the components as shown in figure 8. Put your SKYFi Receiver into the cradle and
DELPHI SA10046 | Installation Guide - Page 11
cables through 11 the hole in the bottom of the splash- Warning: The Delphi XM SKYFi Marine Kit proof case, and reconnect them to the case is splash-proof, NOT waterproof. Do not submerge the case containing your SKYFi Receiver. Doing so cradle as shown in figure 2 on page 3. could result in
DELPHI SA10046 | Installation Guide - Page 12
Delphi XM SKYFi Marine Kit comes with a marine ball-joint mount that can be installed as follows: 1. Attach the splash-proof case to the or access to controls. Do not install the ball-joint mount on a leather surface. Also be sure to identify access routes for the cables, XM for instructions on
DELPHI SA10046 | Installation Guide - Page 13
surface in a adhesion before attaching a load (e.g., 3. Secure base of mount with the stainless circular motion or back and forth. Dry area Delphi XM SKYFi Marine Kit) to the mount. screws provided. 4. To provide a finished look, apply a small bead of white silicone around the base. Caution: Be
DELPHI SA10046 | Installation Guide - Page 14
void your warranty. Delphi Product and Service Solutions ("Delphi") warrants all Delphi XM SKYFi Marine Kit Products sold by Delphi edge of a Delphi's warranty with respect to Delphi XM SKYFi Marine Kit Products is limited to one (1) year mounting surface at a 90-degree from the date of sale
DELPHI SA10046 | Installation Guide - Page 15
TO MODIFY OR ADD TO THIS LIMITED WARRANTY. To purchase accessories for your Delphi satellite radio, visit http://www.shopdelphi.com. written instructions, (iii) alteration or modification of a If warranty service is needed at any time during the Product, (iv) misuse, (v) neglect, (vi) abuse
DELPHI SA10046 | Installation Guide - Page 16
must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Delphi could void the user's authority to operate this equipment. The SKYFi name, XM name, and related logos are trademarks of XM Satellite Radio Inc.