DELPHI SA10046 Installation Guide - Page 11

2. Thread the component cables through 11 the hole in the bottom of the splash- Warning: The Delphi XM SKYFi Marine Kit proof case, and reconnect them to the case is splash-proof, NOT waterproof. Do not submerge the case containing your SKYFi Receiver. Doing so cradle as shown in figure 2 on page 3. could result in personal injury, and/or damage to your 3. Being careful to situate the cables at the bottom of the splash-proof case, align the raised square on the back of the cradle SKYFi Receiver. The cover needs to be completely closed and the latches should be locked in order for the case to be splash-proof. with the recessed square in the splashproof case and gently snap into position. 4. Using the two enclosed stainless screws, screw the cradle to the splash-proof case. 5. The top half of the splash-proof case may Note: To operate your SKYFi Receiver when installed in the splash-proof case, either remove the clear top cover momentarily, or use the remote control. be placed on top of the lower half, making sure the rubber gasket completes a seal. Snap the two clamps (one on each side) into place to secure your splash-proof case.