Danby DPAC12099 Product Manual - Page 7

FEATURES OF THE CONTROL PANEL OPERATING INSTRUCTIONS KEY PAD FUNCTIONS POWER SWITCH:Turns unit ON/OFF MODE: Allows you to scroll through and select desired operating mode. FAN: Select from three different fan settings; High, Medium, and Low. AUTO-TIMER AUTO-TIMER Adjust: Auto off- With machine in running mode, press timer button to set timer control. Press or buttons to select number of hours you would like the unit to run before it automatically shuts off. Auto on- With machine in stand by mode, press timer button to set timer control. Press or buttons to select number of hours before the unit automatically starts running in air conditionning mode. NOTE: The time is adjustable between 1-24 hours. TEMPERATURE Adjust: • Used for adjusting the thermostat. • The default display is room temperature. • In cooling mode, when button is pressed, the set temperature is displayed and may be adjusted. After 15 seconds the display will revert back to room temperature. Temperature is only adjustable in cool mode. NOTE: By pressing both buttons at the same time for more than 3 seconds, the display will toggle between Celsius and Fahrenheit. STATUS DISPLAY Warning Light Condensed water may accumulate in the unit. If the internal tank becomes full, the Warning signal in the LCD Display will light up and the unit will not operate until the unit has been drained. Timer & Temp. Display Room Temp. Temp. Set Timer Set MODE INDICATOR LIGHTS Cooling Mode When cool mode is selected, the indicator light will shine GREEN. During the cooling mode, the air is cooled and hot air is exhausted outside through the exhaust tube. Adjust fan speed to suit your desired comfort level. Note: The air exchange h ose must vent outside the room when using cool mode. Dehumidify Mode When dehumidify mode is selected, the indicator light will shine ORANGE. Air is dehumidified as it passes through the unit, without being in full cooling mode. The fan will operate on med. speed. If room temperature is >25°C (77°F), fan speed can be adjusted; otherwise fan speed is fixed to "low". Note: The warm air exchange hose must vent inside the room when using Dehumidify Mode, not outside as it does when cooling. If the unit is vented outside, some cooling will occur. Fan Mode When fan mode is selected, the indicator will shine YELLOW. Air is circulated throughout the room with no cooling. Note: The unit does not need to be vented in Fan mode. • During Fan/Dehumidifier mode, the temperature cannot be set. FAN SPEED INDICATOR LIGHTS High Fan Medium Fan Low Fan NOTE: AFTER SWITCHING THE AIR CONDITIONER OFF, YOU MUST WAIT 3 MINUTES BEFORE SWITCHING IT BACK ON AGAIN. 6