Dell Force10 E600i FTOS Configuration Guide FTOS 8.4.2.8 E-Series TeraScale - Page 809

Show Redirect List Configuration To view the configuration redirect list configuration, use the following command in EXEC mode: Command Syntax show ip redirect-list redirect-list-name show cam pbr show cam-usage Command Mode Purpose EXEC View the redirect list configuration and the associated interfaces. EXEC View the redirect list entries programmed in the CAM. List the redirect list configuration using the show ip redirect-list redirect-list-name command. The non-contiguous mask is displayed in dotted format (x.x.x.x). The contiguous mask is displayed in /x format. Some sample outputs are shown in Figure 37-10, Figure 37-11, and Figure 37-12. Figure 37-10. Showing Redirect List Configuration Example 1 FTOS#show ip redirect-list xyz IP redirect-list xyz: Defined as: seq 5 redirect 3.3.3.3 ip host 222.1.1.1 host 77.1.1.1 Use the show ip redirect-list (without the list name) to display all the redirect-lists configured on the device. Figure 37-11. Showing Redirect List Configuration Example 2 FTOS#show ip redirect-list IP redirect-list rcl0: Defined as: seq 5 permit ip 200.200.200.200 200.200.200.200 199.199.199.199 199.199.199.199 seq 10 redirect 1.1.1.2 tcp 234.224.234.234 255.234.234.234 222.222.222.222/24 eq 40 ack, Next-hop reachable (via Gi 8/1), ARP resolved Non-Contiguous Bitmasks Applied interfaces: Gi 8/0 Contiguous Bitmasks Note: If, the redirect-list is applied to an interface, the output of show ip redirect-list redirect-list-name command displays reachability and ARP status for the specified next-hop. Policy-based Routing | 809