Dell Force10 S4810P Installing the S4820T System - Page 25
Two-post Flush-mount Configuration
View all Dell Force10 S4810P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Two-post Flush-mount Configuration 1 For this configuration, you must remove the castings from the front side of each ReadyRails assembly. Refer to Figure 4-2, step 1. Use a Torx driver to remove the two screws from each front flange ear (on the switch side of the rail) and remove each casting. Retain the castings for future rack requirements. It is not necessary to remove the rear flange castings. Figure 4-2. Two-post Flush-mount Configuration 2 Attach one rail to the front post flange with two user-supplied screws. Refer to Figure 4-2, step 2. 3 Slide the plunger bracket forward against the vertical post and secure the plunger bracket to the post flange with two user-supplied screws. Refer to Figure 4-2, step 3. 4 Repeat this procedure for the second rail. Installing the S4820T | 25