Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Configuraiton Guide for the E-Series T - Page 465

Enable Link Dampening Enable link dampening using the command dampening from INTERFACE mode, as shown in Figure 21-30. Figure 21-30. Configuring Link Dampening R1(conf-if-gi-1/1)#show config ! interface GigabitEthernet 1/1 ip address 10.10.19.1/24 dampening 1 2 3 4 no shutdown R1(conf-if-gi-1/1)#exit View the link dampening configuration on an interface using the command show config, or view dampening information on all or specific dampened interfaces using the command show interfaces dampening from EXEC Privilege mode, as shown in Figure 21-31. Figure 21-31. Viewing all Dampened Interfaces Force10# show interfaces dampening InterfaceState Flaps Penalty Half-LifeReuse SuppressMax-Sup Gi 0/0 Up 0 0 5 750 2500 20 Gi 0/1 Up 2 1200 20 500 1500 300 Gi 0/2 Down 4 850 30 600 2000 120 View a dampening summary for the entire system using the command show interfaces dampening summary from EXEC Privilege mode, as shown in Figure 21-32. Figure 21-32. Viewing a System-wide Dampening Summary Force10# show interfaces dampening summary 20 interfaces are configured with dampening. 3 interfaces are currently suppressed. Following interfaces are currently suppressed: Gi 0/2 Gi 3/1 Gi 4/2 Force10# Clear Dampening Counters Clear dampening counters and accumulated penalties using the command clear dampening, as shown in Figure 21-33. Interfaces | 465