Dell Force10 S50-01-GE-48T FTOS 8.4.2.7 Configuration Guide for E-Series TeraS - Page 34

www.dell.com | support.dell.com Conventions This document uses the following conventions to describe command syntax: Convention keyword parameter {X} [X] x | y Description Keywords are in bold and should be entered in the CLI as listed. Parameters are in italics and require a number or word to be entered in the CLI. Keywords and parameters within braces must be entered in the CLI. Keywords and parameters within brackets are optional. Keywords and parameters separated by bar require you to choose one. Information Symbols Table 1-1 describes symbols contained in this guide. Table 1-1. Information Symbols Symbol ces et ex * Warning FTOS Behavior Platform Specific Feature E-Series Specific Feature/Command Exception Description This symbol informs you of an FTOS behavior. These behaviors are inherent to the Dell Force10 system or FTOS feature and are non-configurable. This symbol informs you of a feature that supported on one or two platforms only: e is for E-Series, c is for C-Series, s is for S-Series. If a feature or command applies to only one of the E-Series platforms, a separate symbol calls this to attention: et for the TeraScale or e x for the ExaScale. This symbol is a note associated with some other text on the page that is marked with an asterisk. Related Documents For more information about the Dell Force10 E-Series, C-Series, and S-Series refer to the following documents: • FTOS Command Reference • Installing and Maintaining the System • FTOS Release Notes 34 | About this Guide