Dell Inspiron 14 M4010 Inspiron 14 AMD M4010 Service Manual - Page 20

Back to Contents Page Display Dell™ Inspiron™ N4010 Service Manual Display Assembly Display Bezel Display Panel Display Hinges Hinge Caps WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer). CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer. Display Assembly Removing the Display Assembly 1. Follow the instructions in Before You Begin. 2. Remove the battery (see Removing the Battery). 3. Follow the instructions from step 3 to step 4 in Removing the Optical Drive. 4. Remove the module cover (see Removing the Module Cover). 5. Remove the memory module(s) (see Removing the Memory Module(s)). 6. Remove the keyboard (see Removing the Keyboard). 7. Remove the palm rest (see Removing the Palm Rest). 8. Remove the two screws that secure the display assembly to the computer base. 9. Turn the computer over and open the display as far as possible. 10. Disconnect the antenna cables from the Mini-Card(s) (see Removing the Mini-Card(s)). 11. Disconnect the display cable from the connector on the system board, and remove the display cable grounding screw.