Dell Latitude E6400 Replacing the System Board - Page 3
Programming the Service Tag - battery
View all Dell Latitude E6400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Programming the Service Tag After replacing the system board for Latitude E5400, E5500, and Dell Precision M6400 Mobile Workstations, you need to program the service tag if the following message is displayed on startup: WARNING: The Service Tag has not been programmed. This system will not function properly without a Service Tag. The setup utility will launch the Service Tag installer. NOTE: Latitude and Dell Precision E-Series Workstation computers configured with iAMT® receive this message only after the iAMT initialization procedures are completed. NOTE: The battery light on the computer flashes blue and amber during this error. To program the Service Tag: 1 Press to enter the system setup program. 2 Enter the correct Service Tag. 3 Perform one of the following steps: • If the AC Adapter is already connected, exit the system setup program and reboot the computer. • If the AC Adapter is not connected, turn the computer off, connect the AC adapter, and then turn the computer back on.