Dell OptiPlex 7080 Small Form Factor Dust Filter Install Guide - Page 4

Dust Filter for OptiPlex Small Form Factor - what is small form factor computer

Get Dell OptiPlex 7080 Small Form Factor PDF manuals and user guides View all Dell OptiPlex 7080 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

1 Dust Filter for OptiPlex Small Form Factor The dust filter for the Dell OptiPlex Small Form Factor helps protect the system from fine dust particles. After installation, the BIOS can be enabled to generate a preboot reminder to clean or replace the dust filter based on the time interval set. About this task Follow these steps to install the dust filter: Steps 1. Align the top edge of the dust filter to the top edge of the system. 2. Press the lower edge of the dust filter to close over the system. 3. Gently press as shown to ensure that the filter fits snugly onto the system. NOTE: Dust filter design may vary. 4. Restart the system and press F2 to enter the BIOS Setup menu. 5. In the BIOS Setup menu, go to System Configuration > Dust Filter Maintenance and select from any of the following intervals: 15, 30, 60, 90, 120, 150, or 180 days. NOTE: Default setting: Disabled. NOTE: Alerts are generated only during a system reboot and not during normal operating system operation. 4 Dust Filter for OptiPlex Small Form Factor

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
Dust Filter for OptiPlex Small Form Factor
The dust filter for the Dell OptiPlex Small Form Factor helps protect the system from fine dust particles. After installation, the
BIOS can be enabled to generate a preboot reminder to clean or replace the dust filter based on the time interval set.
About this task
Follow these steps to install the dust filter:
Steps
1.
Align the top edge of the dust filter to the top edge of the system.
2.
Press the lower edge of the dust filter to close over the system.
3.
Gently press as shown to ensure that the filter fits snugly onto the system.
NOTE:
Dust filter design may vary.
4.
Restart the system and press
F2
to enter the BIOS Setup menu.
5.
In the BIOS Setup menu, go to
System Configuration
>
Dust Filter Maintenance
and select from any of the following
intervals: 15, 30, 60, 90, 120, 150, or 180 days.
NOTE:
Default setting: Disabled.
NOTE:
Alerts are generated only during a system reboot and not during normal operating system operation.
1
4
Dust Filter for OptiPlex Small Form Factor