Dell PowerConnect 2748 User's Guide - Page 52
Configuring LAG Membership, Interface, PVID 1-4095, Frame Type, Admit Tag Only, Admit All - vlan configuration
View all Dell PowerConnect 2748 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Figure 6-6. VLAN Interface Settings Interface - Indicates the interface number of the port, LAG, or VLAN that is configured on the switch. PVID (1-4095) - Assigns a VLAN ID to untagged packets. The possible field values are 1-4094. VLAN 1 is used as the default VLAN. The default VLAN is only used as a port default VLAN ID (PVID). VLAN 1 cannot be deleted from the system. VLAN 4095 is defined as the discard VLAN, thus the packets classified to this VLAN are dropped. All ports must have a PVID defined; if no other PVID value is configured, the default VLAN's VID will be used. Frame Type - Packet type accepted by the LAG. The possible values are: Admit Tag Only - Only tagged packets are accepted by the interface. Admit All - Tagged and untagged packets are accepted by the interface. Ingress Filtering - Enables or disables incoming filtering by the interface. Ingress filtering discards packets which do not include an ingress port. Updating the VLAN Interface Settings 1 Open the VLAN Interface Settings page. 2 Select the interface (port or LAG) 3 Click Apply Changes. The switch VLAN Port Settings parameter(s) change(s) is applied. Configuring LAG Membership The switch supports six LAGs per system and four ports per LAG. When a port is added to a LAG, it acquires the properties of the LAG. 52