Dell PowerEdge 2300 Service Manual - Page 41

Diskette drive 0 seek failure Diskette drive 1 seek failure Diskette read failure Diskette subsystem reset failed Diskette write protected Drive not ready Embedded server management error Faulty or improperly inserted diskette, incorrect configuration settings in System Setup program, loose diskettedrive interface cable, or loose power cable Faulty diskette, faulty or improperly connected diskette-drive interface cable, or loose power cable Faulty diskette-drive controller (defective system board) Diskette write-protect feature activated Diskette missing from or improperly inserted in diskette drive Embedded servermanagement memory may be temporarily corrupted Replace the diskette. Run the System Setup program to correct the diskette drive type. Check the diskette-drive interface cable and power cable connections to the drive. Check the diskette-drive interface cable and power cable connections to the drive. Replace the diskettedrive interface cable. Replace the system board. Move the write-protect tab on the diskette. Reinsert or replace the diskette. Shut down the system to clear the memory, and then restart the system. Embedded server management is not present Gate A20 failure General failure Hard disk controller failure Hard disk drive read failure Hard disk failure Faulty keyboard controller Replace the system board. (defective system board) Operating system corrupted or not installed properly Reinstall the operating system. Incorrect configuration settings in System Setup program, improperly connected hard-disk drive, faulty hard-disk drive controller subsystem (defective system board), or loose power cable Check the hard-disk drive configuration settings in the System Setup program. Reinstall the hard-disk drive. Check the interface cable and power cable connections to the backplane board. Codes and Messages 3-5