Dell PowerEdge 2800 Rack- to-Tower Conversion Guide - Page 29
Inside the drive tray, open the control panel cable clamp. See
View all Dell PowerEdge 2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Y1001bk0.book Page 27 Thursday, July 8, 2004 4:32 PM Figure 1-16. Drive Tray in the Maintenance Position captive screw drive tray release lever 2 Remove the control panel assembly. a Orient the system as shown in Figure 1-17. b Disconnect the control panel cable from the SCSI backplane. c Inside the drive tray, open the control panel cable clamp. See Figure 1-17. d Using a #2 Phillips screwdriver, remove the two screws that secure the control panel assembly to the rack front panel. e Slide the control panel assembly back away from the front panel and remove the assembly from the chassis. NOTE: While removing the control panel assembly, be careful not to damage the interface cable. Tower-to-Rack and Rack-to-Tower Conversion Guide 27
Tower-to-Rack and Rack-to-Tower Conversion Guide
27
Figure 1-16.
Drive Tray in the Maintenance Position
2
Remove the control panel assembly.
a
Orient the system as shown in Figure 1-17.
b
Disconnect the control panel cable from the SCSI backplane.
c
Inside the drive tray, open the control panel cable clamp. See Figure 1-17.
d
Using a #2 Phillips screwdriver, remove the two screws that secure the control panel
assembly to the rack front panel.
e
Slide the control panel assembly back away from the front panel and remove the assembly
from the chassis.
NOTE:
While removing the control panel assembly, be careful not to damage the interface cable.
captive screw
drive tray
release lever
Y1001bk0.book
Page 27
Thursday, July 8, 2004
4:32 PM